![]() |
|
|
|
#1
|
|||
|
|||
|
got the ortofon concorde pro s
and to balance the tonearm, i turned the ring around the place where the tonearm attaches, and lifted the height.... and now whenever i lift the needle off of the record, and i close the cover, it bumps the needle cos i've got it up so high... so i've got the tracking force at 4 grams, but i don't know how high to set the height. any suggestions? i'm just using the rubber mat, not a slipmat.
|
|
#6
|
|||
|
|||
|
Re: got the ortofon concorde pro s
well, it's not skipping or anything (in fact it's not skipping at all, even less than when i had the stanton), and the tonearm isn't bending down to touch the record or anything, whereas before it was bending upwards to touch the record. so maybe i'll just keep it that way. the brush included is to brush off the needle, right? i'm afraid i'm tearing it up, those bristles are kind of tough.
|
|
#8
|
|||
|
|||
|
Re: got the ortofon concorde pro s
Quote:
|
|
#9
|
|||
|
|||
|
Re: got the ortofon concorde pro s
Quote:
|
| Post Reply |
|
|